Installing The Koos Isize R1 With The Comfy Base In The Car - JANE KOOS iSize R1 Manual Del Usuario

Carry handle, with 3 positions:
Position 1: Resting. In this position the handle lies flat against the frame.
This position is free, it does not lock.
Position 2: CARRYING. Making it easier to carry.
Position 3: CAR. Anti-rotation position for use in the car.
To change the position, press both buttons
to the required position. To move it from the resting position it is not
necessary to press the buttons, simple move the handle.
1
Adjust the height of the harness by simply pressing a button. Avoids
the inconvenience of having to remove and then fit the straps again
when you need to change the height of the belts.
Removable and washable upholstery.
24
EN
2
.d and turn the handle
2
3
F. INSTALLING THE KOOS iSIZE R1 WITH THE
COMFY Base IN THE CAR
INSTALLING THE COMFY Base IN YOUR CAR
Not all systems are the same, therefore we advise you to test your
COMFY Base in the car where it is going to be installed. To install the
platform, read your vehicle instruction manual, it will tell you which
seats are compatible with the platform. The COMFY Base is compatible
with the ISOfix category D.
The anti-rotation leg (1) is an important safety feature, fit it correctly so
it is supported by the floor of the vehicle. If the leg support surface is
not the actual vehicle chassis (luggage compartment for example) do
not install the platform on this seat. To do this, follow the steps below:
Position the base on the seat with the anti-rotation leg (1) and the
fastening bar (9) unfolded. Extend the leg with the help of the upper
adjustment button (5a), until the window indicator shows OK and the
button changes to green. 1 .a
Extract the ISOfix anchors (2) by turning the handle (4) on the side of
the platform. 1 .b
Guide both anchors (2) towards the ISOfix connectors of your vehicle
and press until both sides are locked. Two green signals on the top
part of the ISOfix (2) will show you that they are correctly anchored.
If one or both of the signals are red, repeat this step. 1 .c