Fitting The Koos Isize R1 Onto Your Jané Pushchair; Hood - JANE KOOS iSize R1 Manual Del Usuario

Adjust the harness system by pulling on the center belt so that the
harness fits snugly against the baby's body.
WARNING: Check and adjust the height and length of the shoul-
!
der straps as the baby grows.
I. FITTING THE KOOS iSIZE R1 ONTO YOUR JANÉ
PUSHCHAIR
Your KOOS iSIZE R1 can be fastened onto any JANÉ chassis fitted with the
Pro-fix connectors (always check the pushchair instructions before
fitting the KOOS iSIZE R1).
To fasten the safety seat onto a chassis, insert the Pro-fix connectors
into the slots in the chassis and press.
tened correctly when you hear it lock into place and a green strip is
displayed on the Pro-fix lever (found on the handle joint).
To release the KOOS iSIZE R1 from the chassis, simultaneously pull the
release levers upwards found on both sides of the chassis joints and
lift the baby carrier up. .c
5
4 .i
.a Your KOOS iSIZE R1 is fas-
5
.b
5
! WARNING: The KOOS iSIZE R1 should always be attached to the
pushchair so the baby is facing the parent.
J. HOOD
The hood of your KOOS iSIZE R1 is detachable. Simply unfasten the elastic
cords on the sides of the upholstery and pull the sides of the hood arch
until it is free. To fit the hood again, follow the same steps in reverse.
WARNING: The hood arch only has one possible assembly
!
position. Make sure that the grey marks on the arch and handle
are aligned as shown in the diagram. 6
.
27
EN