Video Length; Interval; Sense Level; Set Date & Time - Olymbros T3 Manual De Usuario

3.6 Video length

Videos are in AVI format that can be played back on most video players . Use the / but-
tons to select the length of the video recording (3-30 seconds) that is to be made when video
recording is activated . The longer the recording time selected, the less space you will have
available on your memory card .

3.7 Interval

Use the / buttons to select the minimum time period that the camera should wait before
reacting to subsequent activation of the main sensor after the initial recording. During the
selected interval, the camera will not record any images or videos . This prevents the memory
card from being filled up with too many recordings of the same event. You can select between
5 - 59 seconds or 1 - 60 minutes.

3.8 Sense Level

The sensitivity of the main motion sensor is set here . For interior areas and environments with
little interference, such as branches blowing in the wind, select "High". Select "Standard" for
exterior areas and environments with a normal amount of interference, and select "Low"for
environments with a high level of interference . The temperature can also affect the sensitivity .
The "High" setting is suitable for warm ambient temperatures, whereas "Low" should be
selected for cold environments .
3.9 Set Date & Time
Here you can set the time and date. Use the / buttons to switch between the values and
change the selected value with the / buttons. Confirm your settings with the OK button.

3.10 Date Stamp

Here you can choose whether to save your photos with a time stamp Date, Time, Temperature,
Moon Phase will be stamped on the photos and videos if you choose "Date/Time" .
10
10