Setting Up And Connecting; Power Supply; Inserting Sd Card - Olymbros T3 Manual De Usuario

If you are not familiar with the operation of this camera, the following instructions will help
you get a quick overview. Before doing any operation, please make sure you have loaded bat-
teries and plugged the SD card correctly .

2.1 Power supply

• To insert batteries in the device, first open the buckle of the device.
• Insert 8 x 1.5 V AA batteries into the battery compartment .
• Please pay close attention to the polarity, which is marked in the battery compartment.
Otherwise the device will not work and can be damaged .
• Recommend you use high-performance alkaline AA batteries. You can also connect an exter-
nal power supply and rechargeable battery; please sure that voltage matches the camera .
• When connecting an external power supply or battery, the camera will use the external
power preferentially .

2.2 Inserting SD Card

Since the camera has no built-in memory, it can only work if an SD/SDHC memory card is
inserted .
• To insert an SD/SDHC memory card into the memory card slot of the device, push it into the
slot until it clicks into place .
• To remove an SD/SDHC memory card from the memory card slot of the device, press the
protruding edge of the memory card in a little way until it pops out . Then remove the card .
• The contact surfaces of the memory card must be facing towards the front of the camera.
• SD/SDHC memory cards have a locking system to prevent accidental erasure. To protect
the card from write access, slide the switch on the side of the card to the "LOCK" position .
However, the camera can only save data onto the card if the switch is in the other position.

Setting UP And Connecting

7
7