Kohler K-704410 Guia De Instalacion página 11

8. Install the Hanging Brackets — Outside Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set unframed tempered glass directly on the floor.
Insert a bushing into one of the holes at the top of the outside glass panel.
Install a hanging bracket over the glass panel, aligning the hole in the bracket with the bushing.
Insert a blind nut into the hanging bracket hole and bushing. Secure with a #8-32 x 3/8" machine
screw.
Repeat the steps to install the other bracket on the outside panel.
IMPORTANT! The steel side of the roller must be installed against the hanging brackets.
Install the rollers on the same side as the bottom frame leg.
Assemble the rollers and #8-32 x 3/8" machine screws to the hanging brackets through the center
hole of the bracket.
Secure the rollers.
Kohler Co.
Hanging Bracket
Roller
Blind Nut
8-32 x 3/8" Machine Screw
Bolt
Bushing
Install outside panel roller.
Rollers on same side as bottom frame leg
11 1015439-2-C