Kohler K-704410 Guia De Instalacion página 16

Wall Jamb
Bottom
Track
Channel
13. Apply Silicone Sealant
NOTE: Thoroughly clean all dust, dirt, or grease from the bottom track and shower ledge surfaces where
sealant will be applied. Make sure the surfaces are dry.
Apply sealant where the wall jambs and wall meet.
Apply sealant where the wall jambs and bottom track meet.
Fill the channel where the wall jamb and bottom track meet at the front with sealant. Refer to the
illustration for correct placement of sealant.
Allow sealant to fully cure following the sealant manufacturer's instructions before using the
shower/bath.
14. Install the Screw Covers
Install the provided screw covers (6) over the wall jamb screws.
Install the provided screw covers (4) over the bottom frame screws.
Install the provided screw covers (2) over the inside panel guide screws.
1015439-2-C
Apply
silicone
sealant.
16
Screw Cover
Kohler Co.