Kohler K-704410 Guia De Instalacion página 12

K-704410 (Bath):
27-1/2" (69.9 cm)
K-704412, K-704414
(Shower):
33-1/2" (85.1 cm)
9. Install the Door Handles
WARNING: Handles use a strong adhesive to ensure lasting performance. Once handles are placed,
any adjustments to their position must be made immediately (within 20 seconds). You will not be
able to remove handles by hand after 20 seconds.
The inside panel is installed on the showerhead side of the bath or shower.
Find the position of the door handle by locating the center point of each door panel on the side of
the door that the handle will be installed. For bath door K-704410, measure 27-1/2" (69.9 cm) from
the top of each panel. For shower doors K-704412 and K-704414, measure 33-1/2" (85.1 cm) from the
top of each panel. Mark the edge of the door panel with a pencil.
Fold the template and slide it onto the door. The pencil mark should be visible through the small
cutout in the middle of the template. For precise placement, align the center of the mark with the
arrows next to the window on the template.
Peel off the tape liners on the back of the template and press it against the glass until it is firmly
secured.
Use the supplied alcohol cloth to clean the visible glass in the cutout. Peel off the tape liner on the
handle.
Make sure the Kohler logo is up. Position the handle inside the cutout in the handle template.
Press the edges and center of the handle for better contact. If adjustment is needed, reposition the
handle immediately.
Install the second handle on the other side of the inside panel.
Repeat above procedures for outside door panel. Install the handles on the side of the panel closes
to the back wall of the shower enclosure.
Wait one hour and remove the templates by gripping and pulling the white area near the handle.
1015439-2-C
Grab here to
remove.
Mark center of
door from top
to bottom with
a pencil.
12
Glass Door
Align mark in
window with
arrows.
Handle
Fold fits over edge
of glass, template
wraps around.
Template
Kohler Co.