Kohler K-704410 Guia De Instalacion página 15

Inside Panel
12. Install the Inside Panel Guide
NOTE: Perform this step from inside the shower.
Engage the inside panel guide into the opening of the bottom track.
Align the slots in the panel guide with holes in the bottom of the inside frame panel.
Install two #8-18 x 3/8" panhead screws through the slots in the inside panel guide and into the
holes in the bottom frame of the panel. Do not tighten the screws at this time.
Push the panel guide up into the bottom track. The felt should face the outside of the shower.
Lower the panel guide slightly for clearance and tighten the screws. Do not overtighten. If the
screws are overtightened the door may not operate properly.
Move the panel back and forth along the full width of the opening and make sure it operates
smoothly.
If the panel binds, loosen the screws and lower the inside panel guide.
NOTE: If the door still does not operate smoothly, the rollers may need to be adjusted. See the steps in the
"Install the Outside Panel" section.
Kohler Co.
Inside
Panel
Guide
#8-18 x 3/8"
Panhead Screw
15
Inside
Panel
Guide
1015439-2-C