Bosch MIC‑ALM‑WAS‑24 Manual Del Usuario página 33

MIC Alarm-Washer Box
6 Installation
Caution!
Installation must be made by qualified personnel and conform
to ANSI/NFPA 70 (the National Electrical Code
!
Canadian Electrical Code, Part I (also called CE Code or CSA
C22.1), and all applicable local codes. Bosch Security Systems,
Inc. accepts no liability for any damages or losses caused by
incorrect or improper installation.
Notice!
To meet the Mains Supply Voltage Dips and Short Interruptions
i requirements per EN 50130-4 Alarm Standard, ancillary
equipment (for example, UPS) is necessary. The UPS must have
a Transfer time between 2-6 ms and Backup Runtime of greater
than 5 seconds for the power level as specified on the product
data sheet.
Notice!
To maintain the IP (protection) rating of the enclosure, install
i
only listed or recognized glands with the same environmental
rating as the enclosure according to the installation instructions
of the gland.
Note: All item numbers referenced in the following steps refer to
the MIC-ALM-WAS-24 Layout.
To install the MIC-ALM-WAS-24, follow these steps:
1. Select a secure installation location for the device. Ideally,
this is a location where the device cannot be interfered with
intentionally or accidentally and that will ensure that
environmental conditions are within the rated specifications.
To provide maximum protection against EMC interference,
install the device inside an environmentally suitable equipment
cabinet that has a good connection to earth ground.
Bosch Security Systems
Installation | en
®
(NEC)),
2019-12 | 3.0 | F.01U.382.777
33