Bosch MIC‑ALM‑WAS‑24 Manual Del Usuario página 35

MIC Alarm-Washer Box
–
Pin
1
2
3
–
6. Connect the power cable.
–
–
–
–
Pin
1
2
3
–
7. Connect Alarm inputs and outputs, if desired.
–
–
–
–
–
Bosch Security Systems
Make the connections to terminal block P200 (item 8)
according to the table below.
Description / Function
Data-
Ground
Data+
Check that the connections are secure.
Prepare the cable as needed.
Select the cable gland in the most suitable location based
on installation conditions. Item 3 is recommended.
Feed the cable through the cable gland into the enclosure.
Make the connections to terminal block P300 (item 4)
according to the table below.
Description / Function
24VAC
Chassis Ground
24VAC
Check that the connections are secure.
Prepare the cable as needed.
Select the cable gland in the most suitable location based
on installation conditions. Item 14 is recommended.
If you selected the gland location identified as item 14,
remove the M16 plug; insert in its place the extra cable
gland (supplied) for the alarm input / output interface.
Feed the cable through the cable gland into the enclosure.
Make the connections for the alarm inputs (for external
devices such as door contacts or sensors) and alarm
outputs (for switching external units such as lamps, alarm
sirens, or other alarm units) to terminal block P101 (item 6)
Installation | en
2019-12 | 3.0 | F.01U.382.777
35