Bosch MIC‑ALM‑WAS‑24 Manual Del Usuario página 34

34 en | Installation
2. Remove the lid.
–
3. Mount the device to a stable surface, if desired.
–
–
–
Figure 6.1: Dimensions, mounting holes, MIC-ALM-WAS-24
4. Refer to installation information on the lid label.
–
5. Connect the RS-485 communication cable from the camera
to the device.
–
–
–
2019-12 | 3.0 | F.01U.382.777
Loosen the four (4) M4 screws and remove the lid of the
enclosure (item 1).
Locate the four (4) mounting holes (item 2).
If applicable, drill four (4) holes in the mounting surface,
using the figure below as reference.
Secure the enclosure to the mounting surface using M4
(#8) screws and washers (not supplied).
Refer to the label on the inside of the lid of the enclosure
for important installation information.
Prepare the cable as needed.
Select the cable gland in the most suitable location based
on installation conditions. Item 9 is recommended.
Feed the cable through the cable gland into the enclosure.
188 mm
(7.40 in.)
MIC Alarm-Washer Box
Bosch Security Systems