Description Of The Display And Temperature Adjustment - Ravelli RBH 150 V Manual De Uso Y Mantenimiento

EN
Rev.2 15/07/2021
Pag.50
⚠
⚠
The brazier could be very hot: danger of burns!
Never empty the brazier inside the hopper.
��
In stoves with self-cleaning brazier it is sufficient to reset the alarm and turn the stove back on: before loading more pellets,
the stove will try to light any pellets already present in the brazier.
Setting operating temperature and power:
Set the two values following the indications given in the chapter "Description of the display"

Description of the display and temperature adjustment

The Home screen of the handheld display appears differently depending on the hydraulic scheme set during the installation phase.
Diagram 0 (heating system only)
1. Indicates the room temperature measured by the handheld device (if the external thermostat is connected, it indicates whether
it requires ignition with ON t.ext or stove shutdown with OFF t.ext);
2. Icon indicating the status of the stove;
3. Indicates the temperature of the water in the thermo stove.
You can change the room temperature set by tapping the UP arrow key. In this way this part of the display is highlighted and the
currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The confirmation of each
change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An acoustic signal certifies
the change.
You can change the water temperature set by tapping the DOWN arrow key. In this way this part of the display is highlighted and the
currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The confirmation of each
change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An acoustic signal certifies
the change.
Diagram 1 (boiler sensor)
1. Indicates the temperature of the DHW tank to be maintained (if the thermostat is connected to the tank, it indicates whether it
requires heating the domestic water with ON t.ext. or not with OFF t.ext.);
2. Icon indicating the status of the stove;
3. Indicates the temperature of the water in the thermo stove.
It is possible to change the DHW temperature set and the room temperature set by touching the UP arrow key. This will take you to
a new screen which shows the temperatures currently set.
With the UP arrow key you activate the modification of the room temperature (room set) and with the UP and DOWN arrow keys you
can modify this value. Confirmation of any changes takes place automatically.
With the DOWN arrow key you activate the modification of the DHW temperature (set boiler) and with the UP and DOWN arrow keys
it is possible to modify this value. Confirmation of any changes takes place automatically.
You can change the water temperature set by tapping the DOWN arrow key. In this way this part of the display is highlighted and the
currently set temperature is shown. With the UP and DOWN arrow keys it is possible to modify this value. The confirmation of each
change takes place automatically within 3 seconds of the change or by pressing the confirmation button. An acoustic signal certifies
the change.
Use and maintenance manual RBH 150 V - RBH 200 V
1
2
3
1
2
3