Sanitisation Of The Tub; Preliminary Operations - Jacuzzi ARGA Manual De Instrucciones

Sanitisation of
the tub
preliminary
operations
activate
the function
The sanitisation process cannot
be interrupted unless the power is
disconnected via the main switch
Wait for the tub to be empty before
turning off the main switch. This
ensures the pipes are drained fully.
Jacuzzi recommends disinfectant J-MX 07
centre or authorised retailer. J-MX 07 is a quick-acting, long-lasting disinfectant, ideal for
sanitising the tub plumbing circuits. It degreases, cleans and deodorises, and has a wide
range of uses.
(*) product available in selected countries only. For more information, contact a Jacuzzi ® service centre or authorised
retailer
■ It is possible to carry out this cleaning operation with the water used during the Swirl-
pool® function, provided that soap, oils, cosmetics, and bath salts have not been used; if
they have, empty the tub and fill it once again.
In any case, the tub water level (without anybody in the tub) must fully cover the jets.
■ Pour approximately 100 ml of J-MX 07 liquid into the tub water.
■ To activate the function, press and hold the
The jets and display will flash and the pump will activate (for approximately a minute) to
ensure the liquid inside the hydraulic circuit circulates.
The tub is fitted with a sensor which prevents the pump from starting if the water level is too
low. If, when you press the button, the pump does not start and the jets and display flash, add
water and press the button again.
The pump stops even when there is an unexpected drop in the water level, caused (e.g. drain
open). In any case, once the anomaly (power outage, drop in water level, etc.) has been re-
solved, the function can be restarted using the relevant button.
■ The function lasts approximately 10 minutes and is completely automatic (the jets and
the display flash throughout the entire function); about one minute before the end of the
function, the pump activates again to rinse the pipes.
■ When the jets and display stop flashing, the function has finished. Open the drain and
empty the tub.

The water used for sanitization must be emptied as the liquid irritates the
skin.
28
, which can be purchased at a Jacuzzi® service
(*)
J-MX 07
button for approximately 4 seconds.