Symbols - Kobalt KSP 440-06 Manual Del Usario

SYMBOLS

Some of the following symbols may be used on this product. Please study them and learn their mean-
ing. Proper interpretation of these symbols will allow you to operate the product better and safer.
SYMBOLS DESIGNATION
V Volts
A Amperes
Hz Hertz
W Watts
no No Load Speed
Alternating Current
/min Per Minute
PSI Pressure
Safety Alert
Read The Operator's Manual
Eye Protection
Wet Conditions Alert
Risk of Injection
Kickback
Electric Shock
Risk of Explosion
Recycle
EXPLANATION
Voltage
Current
Frequency (cycles per second)
Power
Rational speed, at no load
Type of current
Revolutions, strokes, surface speed, orbits, etc., per
minute
Pressure is measured in pounds per square inch
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and
understand operator's manual before using this product.
Always wear eye protection with side shields marked to
comply with ANSI Z87.1.
Do not expose to rain or use in damp locations.
To reduce the risk of injection or injury, never direct a
water system toward people or pets or place any body
part in the stream. Leaking hoses and fittings are also
capable of causing injection injury. Do not hold hoses or
fittings.
To reduce the risk of injury from kickback, hold the spray
wand securely with both hands when the machine is on.
Failure to use in dry conditions and to observe safe
practices can result in electric shock.
Do not spray flammable liquids.
This product uses lithium-ion (Li-ion) batteries. Local,
state or federal laws may prohibit disposal of batteries
in ordinary trash. Consult your local waste authority for
information regarding available recycling and/or disposal
options.
4