Troubleshooting; Corrective Action - Kobalt KSP 440-06 Manual Del Usario

TROUBLESHOOTING

If you still have questions or an unresolved issue after going through this troubleshooting guide, or
just want to speak to a Kobalt product expert, please call our customer service department at
1-888-3KOBALT (1-888-356-2258), 8 a.m. - 8 p.m., EST, Monday - Sunday.
PROBLEM
Liquid leaks.
Liquid leaks from
the lid.
Tank starts to
collapse; tank lid
cannot be
unscrewed
creating vacuum.
Low or no
pressure.
Tank leaks at pump
connection.
Tank leaks at pump. The hose clamp is loose. Tighten the hose clamp.
Tank leaks at hose
connection.
Diaphragm is
leaking.
The machine does
not start.
POSSIBLE CAUSE
Nut may be loose or rub-
ber seal is cracked or
damaged.
Lid not screwed on tight-
ly or seal is cracked or
damaged.
Vent holes in tank lid
have become clogged.
Battery is out of charge,
switch is in "off" position
or tip nozzle is stuck.
Seals are damaged.
Clamp is loose or
damaged.
Diaphragm is damaged. Replace diaphragm.
The battery is not
charged.
Battery is too cold.

CORRECTIVE ACTION

Tighten the nut and/or replace the seal and lubricate.
Tighten lid. Lubricate the seal, replace if necessary.
Remove cap and with a small wire, unclog the holes.
Clean the cap, check the valve. Lubricate check valve
and reinstall.
Charge the battery to full charge, turn switch to ON
position, unscrew nozzle, and remove debris.
Replace damaged seals
Tighten clamp or replace if damaged.
Charge the battery by following the procedures in the
battery and charger manual.
Remove battery from backpack sprayer. Place battery
on charger and allow to charge for 10 minutes or until
the changing light turns green. Remove from charger
and install in backpack sprayer for use.
17