Technical Specifications; Technical Data - Beta 1883 Instrucciones

OPERATING INSTRUCTIONS
DIGITAL LITRE COUNTER FOR OIL ITEM 1883

TECHNICAL SPECIFICATIONS

- 5-digit liquid crystal display
- Precision: 2 decimals
- Selection of 4 units of measurement: litres, galloons, pints, quarters.
- Exhausted battery indicator
- 4 keys: MOVE, RESET - frontal position - and 1,2 - internal position.
To access keys 1 and 2, remove the shockproof rubber guard, unscrew the 4 PH screws, and remove the
metal cap
THE LITRE COUNTER IS NOT SUITABLE FOR MEASUREMENT WHEN AIMED AT SELLING THE
DELIVERED PRODUCT

TECHNICAL DATA

DELIVERY RATE
MAXIMUM OPERATING PRESSURE
WORKING TEMPERATURE
CALCULATED TOLERANCE
APPLIED TOLERANCE
VISCOSITY
UNITS OF MEASUREMENT
INLETS/OUTLETS
TESTS PRIOR TO USE:
- Check that installation complies with the technical data of the litre counter.
- Check that the input pressure does not exceed 100 bar, and that the ½" inputs/outputs are well tighte
ned.
- Check that the amount of delivered oil shown on the display is the actual amount.
If any differences are shown, correct the calibration factor according to the following formula: DELIVE
RED AMOUNT OF OIL/DISPLAYED AMOUNT OF OIL X CALIBRATION FACTOR.
(see paragraph "using keys")
USING KEYS
"MOVE" key, to give the overall delivered amount
"RESET" key, to give the amount that has just been delivered
Key "1", to change either the calibration factor or the unit of measurement
Key "2", to restart the litre counter, if need be
CHANGING AND DETERMINING CALIBRATION FACTOR:
Press key "2" for a second, to enter the calibration menu. Press the "MOVE" key to select the digit to
change.
Press the "RESET" key to increase the digit to change by one unit, up to a maximum of "9", and then
back to "0".
Press key "2" for a second to quit the calibration menu.
0-35l/min / 0-9.2 gpm
100 bar / 1500 psi
-10°C -+50°C / + 14°F-+122°F
±0.5%
±0.3%
8-5000 mPas
litres, galloons, pints, quarters
½ NPT / ½ BSP
EN
5