Teamtex ENO360 Manual De Instrucciones página 24

EN
INSTALLATION OF THE CHILD CAR SEAT
Group 0+/1 (rear-facing)
(For children who weigh 0-18 kg)
•
Press the
1
buttons in order to extend the Isofix connectors
to their full length.
•
Insert the Isofix connectors into the insertion aids
and press until they lock.
•
The display on both sides only turns green when
the connections have been established. Pull the
child car seat to the back rest until it is standing
securely.
•
Remove the Top-Tether from the bag.
2
•
In order to loosen the Top-Tether, press the grey
adjustment button with one hand and pull the
side of the belt anchor to the required length
with your other hand.
•
Pull the Top-Tether through the belt guide, which
is marked in blue, on the reverse side of the child
car seat.
•
Fix the anchor to the fixation point on the back
of the car seat.
•
Pull the Top-Tether tight by pulling on the oth-
er side of the belt. Make sure that the display is
green.
•
If there is no Isofix system in the vehicle, use the
3
car's 3-point seatbelt.
•
Pull the car's safety belt out to its maximum
length.
•
Guide the safety belt through the belt guide,
which is marked in blue, on the reverse upper
side of the child car seat.
•
Guide the pelvic restraint through both side
guides under the comfort insert.
•
Close the safety belt with the buckle on the car
seat. Make sure that the safety belt is not twisted.
•
Pull the safety belt of the vehicle as tight as
possible and check whether the child car seat is
standing securely.
•
ATTENTION:The rear-facing position that is se-
cured with the vehicle's 3-point seatbelt, is ONLY
permissible for group 0+ (0 - 13 kg)
two lateral Isofix connector
24
- 24 -
4
5
Grou
(For ch
Install
1