User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch WBE 4200 Instructions De Réparation

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.

User information

2.1

Important notes

Important information on copyright, liability and
warranty provisions, as well as on equipment users
and company obligations, can be found in the separate
manual "Important notes on and safety instructions for
Bosch Tire Service Equipment". These instructions must
be carefully studied prior to start-up, connection and
operation of the WBE 4200 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in
the separate manual "Important notes on and safety
instructions for Bosch Tire Service Equipment". These
instructions must be carefully studied prior to start-up,
connection and operation of the WBE 4200 and must
always be heeded.
2.3

Electromagnetic compatibility (EMC)

The WBE 4200 satisfies the requirements of the EMC
directive 2004/108/EG.
i
The WBE 4200 is a class/category A product as
defined by EN 61 326. The WBE 4200 may cause
high-frequency household interference (radio
interference) so that interference suppression
may be necessary. In such cases the user may be
required to take the appropriate action.
Robert Bosch GmbH
User information | WBE 4200 | 37
3.

Product description

3.1

Intended use

The WBE 4200 is a wheel balancing machine featuring
mechanical wheel clamping for the balancing of car,
light van and motorcycle wheels with a rim diameter of
10" - 27" and a rim width of 1" - 20".
The WBE 4200 is to be used exclusively for this purpose
and solely for the range of applications specified in
these instructions. Any other purpose is not consistent
with the intended use and is therefore not permissible.
i
The manufacturer cannot accept any liability for
possible damage arising from improper use.
!
* These measurements refer to standard rims (A); for
particularly shaped rims (B - C) it is recommended
using specific accessories.
A
B
C
3.2

Prerequisites

The WBE 4200 must be installed on a flat surface
made of concrete or similar material and anchored in
position.
!
An uneven or vibrating surface can lead to inaccurate
unbalance measurements.
!
Any uneven floors or that do not meet the previously
expressed safety requisites relieve the manufacturer
from any liability for damages to persons and/or
property.
en
|
1 695 600 091
2012-11-16

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido