Shark ION ROBOT RV750 Serie Guía Del Proprietario página 5

CHARGING THE SHARK ION ROBOT®
CHARGE INDICATOR LIGHTS
In Use
Clean
Dock Max
While
Charging
No Charge
or Off
The blue charge indicator lights show how much charge is remaining.
While the robot is charging, all three blue LED lights will cycle. When charging is complete, all three blue lights
will illuminate steadily.
If the robot is idle and away from the charging dock for 10 minutes, it will enter Sleep Mode, and the lights will
turn off.
If all the indicator lights are off, then the robot is in Sleep Mode, the power switch is turned OFF (O) or there is
no charge remaining. Turn the power switch ON (I). Press any button to ensure robot is not in Sleep Mode. If all
indicator lights remain off, there is no charge. Place the robot on the dock, leaving a half-inch space between
the front of the robot and the face of the dock. When the robot is docked correctly and begins to charge, it Full Charge Nearly Full
will beep and the charge indicator lights will cycle.
NOTE: If the low charge light is blinking red, there is not enough charge for the robot to return to the dock. Manually place
the robot on the dock, leaving a half-inch space between the front of the robot and the face of the dock.
Full Charge
TIP: To preserve battery life, turn off the power switch if robot will not be used for a long period of time. Unit should be
recharged at least once every three months.
USING THE SHARK ION ROBOT®
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the Clean button on the robot or on
the mobile app. To stop the robot before it finishes cleaning and automatically
returns to the dock, press the button again.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
sharkc le a n.com
Full Charge Nearly Full Mid Charge Low Charge
Mid Charge Low Charge
Nearly Full Mid Charge Low Charge
USING THE SHARK ION ROBOT®
BUTTONS AND INDICATOR LIGHTS
Clean
Dock Max
CLEAN BUTTON
Press to begin a cleaning
session. Press again to stop.
Clean
Dock Max
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging dock.
Clean
Dock Max
MAX MODE BUTTON
Press for more powerful
cleaning.
Clean
Dock Max
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
Clean
Dock Max
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
Clean
Dock Max
WI-FI INDICATOR
Blue light: connected to Wi-Fi.
Red light: not connected.
Flashing blue: setup mode.
Clean
No light: not set up yet.
Dock Max
s ha rkc l ea n.co m