Sanus VST4 Manual Del Usuario página 11

4. Place the wall plate template
17
plate and tape in place.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the two pilot holes using a 3 mm (1/8 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.).
6. Remove the wall plate template
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage do not over-
tighten the lag bolts
19
4
17 at your desired height and position the slotted holes over your stud center line. Level the wall plate tem-
. Tighten lag bolts
17
.
5
17
only until they are pulled firmly against the wall plate
19
63.5 mm
(2 1/2 in.)
3 mm
(1/8 in.)
17
.
18
6
19 18
11