Metrohm 799 GPT Instrucciones Para El Uso página 162

3.2. Remote control commands
158
Mode.Parameter.Presel.Temp
Parameters for TIP: Selection of the measured quantity for manual measure-
ments in the inactive state, see 3.2.2.2. Selection of the measuring input
(MeasInput) applies to measured quantities pH and U. "diff." means differen-
tial amplifier, see page 216. With Ipol the requests for the polarization current
in uA (Ipol) and .PolElectrTest apply. With Upol the request for the polarization
voltage in mV (Upol) applies. Entry in steps of 10 mV. .PolElectrTest also ap-
plies. If the test for polarized electrodes is switched on (ON), it will be per-
formed on the change from the inactive state to an active state. The tempera-
ture applies to pH measurements.
3.2.2.77. UserMeth.FreeMem
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g.
"4928".
3.2.2.78. UserMeth.Recall
UserMeth.Recall.Name
UserMeth.Store
UserMeth.Store.Name
UserMeth.Delete
UserMeth.Delete.Name
UserMeth.DelAll
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after en-
tering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.79. UserMeth.List.1.Name
UserMeth.List.1.Mode
UserMeth.List.1.Quantity
UserMeth.List.1.DosUnit
UserMeth.List.1.Bytes
UserMeth.List.1.Checksum
for each method
List of the methods in the user method memory with the following
characteristics:
.Name: Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes: Number of bytes of the user memory used by the method
.Checksum: Checksum of the method, see 3.2.2.133.
3.2.2.80. MemoryCard.Recall
MemoryCard.Recall.Name
MemoryCard.Store
MemoryCard.Store.Name
MemoryCard.Delete
-170....25.0...500.0
read only
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
read only
read only
read only
read only
read only
read only
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
799 GPT Titrino