Metrohm 799 GPT Instrucciones Para El Uso página 173

799 GPT Titrino
3.2.2.138. Info.StatisticsVal.ActN
Info.Statistics.1.Mean
Info.Statistics.1.Std
Info.Statistics.1.RelStd
etc. up to .9
The current values of the statistics calculation.
$Q sends, e.g.
ActN: Current value of the individual results
Data for MN1:
Mean: Mean value (decimal places as in result)
Std: Standard deviation (1 decimal place more than in result)
RelStd: Relative standard deviation (in %, 2 decimal places)
3.2.2.139. Info.SiloCalc.C24.Name
Info.SiloCalc.C24.Value
Info.SiloCalc.C24.Unit
for .C25 as for .C24
Info.SiloCalc.C26.ActN
Info.SiloCalc.C26.Mean
Info.SiloCalc.C26.Std
Info.SiloCalc.C26.RelStd
for .C27 as for .C26
The current values from the silo calculations. C26 is the mean value out of the
C24 variables; C27 comes from C25.
$Q sends:
C24.Name: Name of the assigned value
C24.Value: Value
C24.Unit: Unit of the assigned value
C26.ActN: Number of single results
C26.Mean: Mean (decimal places as for the result itself)
C26.Std: Standard deviation (decimal places as for the result + 1)
C26.RelStd: Relative standard deviation (in %, 2 decimal places)
3.2.2.140. Info.ActualInfo.Inputs.Status
Info.ActualInfo.Inputs.Change
Info.ActualInfo.Inputs.Clear
Info.ActualInfo.Outputs.Status
Info.ActualInfo.Outputs.Change
Info.ActualInfo.Outputs.Clear
Status sends the current status of the I/O lines, Change sends the information
regarding whether a change in status of a line has taken place since the last
clearing, Clear clears the change information. For the output, there is a con-
version from binary to decimal, e.g.
| 0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 | 1 | 0 | 1 | 0 |
Line No.
| 13| 12| 11| 10| 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
Output: 2 1 + 2 3 = "10"
1 means ON or change; 0 means OFF or no change.
The lines are assigned as follows (see also pages 222ff):
Inputs:
0 Start (pin 21)
1 Stop (pin 9)
2 Enter (pin 22)
3.2 Remote control commands
Outputs:
0 Ready (pin 5)
1 Cond. ok (pin 18)
2 Titration (pin 4)
read only
read only
read only
read only
"3"
"3.421"
"0.0231"
"0.14"
read only
read only
read only
read only
read only
read only
read only
"RS1"
"2.222"
"%"
"3"
"3.421"
"0.0231"
"0.14"
read only
read only
$G
read only
read only
$G
169