Slime 40058 Instrucciones página 5

INFLATOR TROUBLESHOOTING:
Inflator does not turn ON (try one or all of the following):
1. Check to see if the tire pressure set point on the digital gauge
is set to a lower PSI than your tire currently is reading (i.e., the
digital gauge is set to 15PSI, but your tire is at 20PSI; in this
scenario, the inflator will not turn on). Refer to the digital
gauge operating instructions and set the PSI to the correct
tire pressure.
2. Check the power plug and push it firmly into the receptacle,
twist back and forth.
3. Check receptacle and plug terminals for dirt, or debris.
(Use a non-conductive probe, not fingers or metal).
4. Check vehicle power outlet fuse. It should be 15 amps minimum.
5. Check the fuse. It may have blown:
12V fuse is located in the plug adaptor:
unscrew the tip, remove fuse, and inspect.
If necessary, replace fuse with 15A 250V 5mm x 20mm.
Inflator runs but does not inflate:
1. Be sure the connector is fully tightened on the valve stem.
2. Check tire for leaks, and check hose for breaks and leaks at fittings.
Inflator runs slowly:
1. Overheated from excessive use. Shut if off and allow to cool for 25 minutes.
2. Voltage too low. Check condition of vehicle battery.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to leak
out when trying to inflate. In the event this occurs, you will have to jack up the tire prior to inflation.
CAUTION: Keep inflator out of reach of children. Do not over-inflate.
Dispose of this product at an e-waste recycling collection point or facility. Do not place in the trash or
standard recycling receptacle.
* (0-35PSI, Standard Tire: P195/65 R15)