Inflation Instructions - Slime 40058 Instrucciones

INFLATION INSTRUCTIONS:

Inflation can be used for auto tires, bicycle tires, sports balls, rafts and other inflatables.
* NOTE: Recommended tire pressure can be found in vehicle owner's manual or on the
driver's side door jamb.
INFLATE RIGHT™ TECHNOLOGY INSTRUCTIONS:
1. Once inflator hose is attached to the valve stem, hold the + or – button for approximately 2
seconds until the display flashes. Set the required pressure using the + or – buttons, then
wait 3 seconds. The display will stop flashing and show the target pressure value to which
the tire will be inflated. (Continuously pressing the + or – button will enter into "Fast setting
mode", increasing or decreasing the rate of target pressure at an increased speed.)
2. Use the toggle switch to power the inflator by sliding it to the inflator icon to begin inflation.
3. When the pressure gauge reaches the pre-set value, the inflator will automatically stop
inflation. Once desired tire pressure is reached, disconnect the air hose, and unplug the
power cord.
1
Screw air hose connector onto tire's valve stem.
2
Plug power cord into 12 volt accessory power outlet.
3
Use the toggle switch to power the inflator by sliding
it to the inflator icon. Inflate tire to manufacturer's
recommended air pressure. Use the Inflate Right
Technology ™ (instructions below) for accurate inflation.
4
When desired pressure* is reached, slide toggle switch
to middle "OFF" position to turn off inflator. UNPLUG
POWER CORD AND REMOVE AIR HOSE CONNECTOR.