Infiniton ROT70 Manual De Usuario página 10

For a good appearance and operation, keep the oven clean. The modern design of the
oven facilitates its maintenance, reducing it to a minimum. The elements of the oven
that come into contact with food should be cleaned regularly.
General cleaning
-Before performing any cleaning or maintenance task, unplug the oven.
-Set all the controls in the OFF position.
-Wait until the inside of the oven cools until it is only slightly hot; Cleaning is easier if the
oven is a little hot.
-Wipe the surfaces with a soft cloth, a sponge or a soft damp sponge and then dry them
with a cloth.
If it is very dirty, use hot water and a non-abrasive cleaning product.
-Do not use abrasive cleaners or sharp metal scrapers to clean the oven glass, as they may
scratch the surface and damage the glass.
-Avoid the contact of acidic substances (lemon juice, vinegar ...) with stainless steel
elements.
-Do not use a high-pressure cleaner to clean the oven.
-The oven trays can be washed with a mild detergent.
Inside the Oven
Appropriate chemicals can be used after consulting the recommendations of the
manufacturer and trying it on a small part of the gap. Abrasive cleaning agents or abrasive
clothes must not be used on the surfaces of the gap.
Do not clean with a jet of steam.
NOTE: The manufacturer of this appliance does not take responsibility for damages
caused by chemicals or abrasive cleaning.
REMOVING SIDE WIRE TRAYS OF THE OVEN
It is possible to remove and clean the side wire
trays in which trays and wire grids are placed
easily. Follow the procedure as shown in the
picture below to remove the oven interior wire
trays from the side walls.
8