Infiniton ROT70 Manual De Usuario página 7

* The walls of the furniture in which the oven is installed must be resistant to heat. The wall panels
must be resistant to 100 ° C, especially if the side walls are made of wallboard. Plastic panels or
adhesives that are not resistant to this heat can be deformed and damaged.
* For safety reasons, direct contact with the electric oven parts should be avoided.
* The insulation and protection parts must be installed in such a way that they can not be removed
with any tool.
* The oven must be installed as in the Figure to provide a more effective air flow.
* It is recommended to leave a space of at least 40 mm in the back of the kitchen unit in which the
oven is installed.
* A support must be placed under the oven that can support the weight when placing the oven.
* The rear section of the cab in the kitchen unit should be re-routed to provide a better fl ow of air.
* It is not recommended to install the device near refrigerators or freezers, otherwise the
performance of these devices would be affected by the radiated heat.
* Place the device centered in the inlaid cabin
* Open the oven lid and mount the body on the countertop with four thumbscrews aligning the
holes on the sides.
* The oven can be mounted in a cabinet above or below the counter, if desired
* When mounting a built-in electric stove on the countertop above the oven, the electricity cords of
the oven and the stove must be separated to remove the oven from the stove when necessary.
SEE THE FIGURE
5