Installing Your Wine Cabinet - Transtherm MAS 1T Manual Del Usuario

ecommendation
important
important

Installing your wine cabinet

When unpacking your cabinet, make sure that there are no traces of impact or
deformation and that there are no surface defects.
Carefully remove all of the protections and adhesive strips from the packaging
around your wine cabinet.
Open the door and make sure all components are intact.
Release the electrical lead.
Move your cabinet to its final location.
The place you have selected for your cabinet should:
- Be unencumbered and well ventilated,
- Enable a minimum 10 cm space between the wall and the back of the cabinet,
- Be well away from any heat source,
- Not be too damp (laundry, pantry, bathroom, etc.),
- Have a solid and flat floor,
- Have a standard and accessible electricity supply (standard socket to country
standards, linked to ground with differential trip),
- It is NOT recommended to use a multi-socket or extension lead.
In order for you to level off your cabinet as easily as possible, it is equip-
ped with 4 adjustable feet. However, we do recommend that you tighten
the back feet to the maximum and use the front feet to create a level (a spi-
rit level is recommended for this operation).
WAIT 48 HOURS BEFORE PLUGGING IN THE CABINET
Should you need to move your cabinet, never tilt it more than 45° and always
sideways, on the side that the electrical cable comes out (right hand side when
looking at the cabinet).
As a security measure, the lock works on a
double movement system. The key should
be pushed inward and turned at the same
time.
GB
P 5