Multi-Temperature Models - Transtherm MAS 1T Manual Del Usuario

Temperature settings for multi-temperature models
The temperature control(s) and setting(s) are adjusted from your wine cabinet's
settings panel, as shown below.
Hot circuit indicator light (Red)
Lower temperature
display
Lighting (LED1)
Multi-temperature cabinet models have a temperature range starting at 6°C to 8°C
(42°F to 46°F) at the bottom and reaching 14°C to 18°C (57°F to 64°F) at the top.
• In the lower section, the original set temperature is 7°C, on leaving the factory.
It is possible to adjust the temperature setting. Please note, however, that there is
no upper or lower limit.
Please note: Its recommended setting range is 6°C to 8°C (42°F to 46°F).
To adjust the temperature of your "lower" section:
Comments: As soon as you see the display flash during setting, you have approximately 50
seconds to change or confirm, otherwise, you must restart the process.
If the setting has not been recorded, your cabinet will retain its original settings.
Press and hold down the
Press , "F4" will appear on the display ("F4": chilling compartment tempera-
ture setting).
Press You will be able to read the set temperature displayed.
Press to increase the set temperature, or
Press to lower the set temperature.
To record your setting, press
perature is displayed. Otherwise, it will be necessary to restart the process.
Otherwise, it will be necessary to restart the process.
« ST »
Pressing! for
5 seconds
« F4 »
allows you
to access:
« H4 »
Upper temperature
display
Keyboard
Lighting (LED2)
key for 5 seconds. "St" will appear on the display.
the button and hold for 5 seconds, until the tem-
"ST" allows you to set the wine
maturing temperature (for 1 and 3
temperature models) or the upper
section (for multi-temperature
models).
Allows you to change from "ST" to "F4" then "H4".
"F4" Allows you to set the tempera-
ture of the chilling compartment (for
3 temperature models) or the lower
section (for multi-temperature
models)
Allows you to change from "ST" to "F4" then "H4"
"H4" Allows you to activate or disa-
ble the warning alarm, if a malfunc-
tion occurs.
Lighting General ON / OFF
ON / OFF switch
switch
Cold circuit indicator light (Green)
Pressing Set: Allows you to read
the set temperature of the "ST"
setting.
Pressing Set twice: Allows you to
return to the "ST" display
Pressing Set: Allows you to read
the set temperature of the "F4"
setting.
Pressing Set twice: Allows you to
return to the "F4" display.
Pressing Set: Allows you to read
the "H4" setting value:
H4=O means that the warning
alarm is active.
H4=1 means that the warning
alarm is disabled
Pressing Set twice: Allows you to
return to the "F4" display.
P12