All Models - Transtherm MAS 1T Manual Del Usuario

important
important
• In the "upper" section, its original temperature setting is 16°C (60°F), on lea-
ving the factory. It is possible to adjust the temperature setting.
It is possible to adjust the temperature setting, within a recommended range of
14°C to 18°C. (57,2 to 64,4 F°)
Please note that the lower and upper limits of this setting range are 6°C and 18°C
(42,8 to 64,4 F°) respectively.
To adjust the temperature of your "upper" section:
Please note:
- Once you see the display flash during setting, you have about 50 seconds to change or
confirm your setting,
- If no setting has been recorded, your cabinet will retain its original settings.
Press and hold down the key for 5 seconds. "St" will appear on the display ("St":
maturing temperature setting).
Press you will be able to read the set temperature displayed*.
Press to increase the set temperature, or
Press to reduce the set temperature.
To save your setting, press the
rature is displayed.
Otherwise, it will be necessary to restart the process.
Please note:
- The lighting function is manually controlled ("Light" On/Off switch). If you are no longer
using it, remember to switch off the lighting.
Temperature Settings for all models
°C / °F Conversion Table
°C °F
6 42
8 46
10 50
12 54
14 57
16 60
18 64
20 68
It may be that despite the recommendations in this manual, you still do not
achieve quite the desired temperature. Every situation is unique, and it may
be that a few slight corrections are needed.
You will need to wait approximately 48 hours before noticing the effects of
a temperature adjustment.
otherwise you will
button and hold for 5 seconds, until the tempe-
have to restart the process.
GB
P 13