Safe Operation - Oase Aquarius Universal 440 Instrucciones De Uso

- GB -
− Ensure that the unit is fused for a rated fault current of max. 30 mA by means
of a fault current protection device.
− Extension cables and power distributors (e.g. outlet strips) must be suitable for
outdoor use.
− Ensure that the power connection cable cross section is not smaller than that of
the rubber sheath with the identification H05RN-F. Extension cables must meet
DIN VDE 0620.
− Protect the plug connections from moisture.
− Only plug the unit into a correctly fitted socket.

Safe operation

− Never operate the unit if either the electrical cables or the housing are
defective!
− Do not carry or pull the unit by its electrical cable.
− Route all cables such that damage is excluded and nobody can trip over them.
− Never open the unit housing or its attendant components, unless this is
explicitly required in the operating instructions.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− Only have repairs carried out by customer service points authorised by OASE.
− The power connection cables cannot be replaced. When the cable is damaged,
the unit or the component needs to be disposed of.
− Only operate the unit if no persons are in the water!
− Keep the socket and power plug dry.
Important! The unit is equipped with a permanent magnet. The magnetic
field may affect the function of pacemakers.
Start-up
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always
place the unit below water level.
How to operate the unit:
Install the pump ensuring that it is completely submerged. Allow the air in the
pump to fully escape. Ensure that the maximum permissible immersion depth of 1
m is not exceeded.
The required delivery volume can be set at the control lever:
To set the maximum delivery volume, slide the control lever fully to the left, in the
„+" direction.
To reduce the delivery volume, slide the control lever to the right, in the „–" directi-
on.
10