Use With Sunshades (Fig.4) - tau MRT Serie Guía Para La Instalación

3.2 Use with sunshades (Fig.4)

- Act on the upper screw to adjust shutter opening.
- Act on the lower screw to adjust closure.
motor installed on the left
1. After installing the motorised roller, turn it to open the shutter, until it stops at the limit
switch.
2. Turning the upper screw anticlockwise, turn the roller to a suitable position to fasten the shade
to the roller.
3. Fasten the shade to the roller.
4. Using the switch, close the shade; after the roller stops at the limit switch, turn the lower
adjusting screw anticlockwise to the required position.
Positioning errors: if during closure the required stop position is exceeded, open the shade
for a short distance using the switch, and adjust the lower screw clockwise a few turns. Repeat
operation 4 above.
Notes:
- Adjust the lift stop point with a reasonable tolerance as regards the mechanical stop point of
the awning.
- Check the system a few days after installation and adjust the limit switch if necessary in order
to recover any play of the cloth.
4. MANUAL OVERRIDE (OR EMERGENCY OVERRIDE)
As for all types of installations, take great care to ensure the motor remains at right-angles to its
fixing surface (static part) Fig. 5.
16
motor installed on the right
Fig. 4
Fig. 5
MRT / MRTS