Installation Instructions; Part Numbers; All Models - Cequent Performance Products 41943 Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles



HEX BOLT – 9/16" – 18 X 1.75" GR5

Qty. (8)



WASHER – 9/16" HARDEN FLAT

Qty. (12)



FLANGED LOCKNUT – 9/16"-18

Qty. (8)



HEX BOLT – M14X1.5 X 45mm CL10.9

Qty. (4)



FLANGED NUT – M14X1.5 CL10

Qty. (2)

WARNING: THE FUEL FILLER HOSE AND ELECTRICAL WIRES ARE LOCATED ABOVE SOME OF THE HOLES ON THE

DRIVER'S SIDE FRAME RAIL. A WOOD OR METAL SHEILD MUST BE PLACED BETWEEN THE FRAME AND THE FUEL

TANK TO PREVENT PUNCTURING THE FUEL FILLER HOSE OR DAMAGING THE ELECTRICAL WIRES WHEN THE DRILL

BREAKS THRU THE FRAME.

F350 MODELS

1. RAISE SIDE BRACKETS UP INTO POSITION, ALIGNING THE RIVET CLEARANCE HOLE AND NOTCH IN BRACKET WITH

RIVETS. CLAMP TO FRAME RAIL. (SEE FIGURE 2)

F450 MODELS

1. RAISE SIDE BRACKET INTO POSITION AND ALIGN EXISTING HOLE IN FRAME WITH FORWARD ATTACHMENT HOLE.

ALIGN THE RIVET CLEARANCE HOLES WITH OUTER MOST RIVETS. CLAMP TO FRAME RAIL. (SEE FIGURE 3)

ALL MODELS

2. USE THE CENTER SECTION OF THE HITCH TO CHECK WIDTH BETWEEN SIDE BRACKETS AND ADJUST IF NECESSARY.

3. USING THE SIDE BRACKET AS A TEMPLATE, MARK THE HOLES ONTO THE FRAME AND TAKE DOWN THE SIDE

BRACKETS TO ALLOW DRILL ACCESS. DRILL THE CENTER HOLES (ALL MODELS) USING A 1/2" DRILL. USE A 9/16"

DRILL FOR THE FORWARD AND REARMOST ATTACHMENTS (ALL MODELS).

4. LOOSELY INSTALL FASTENERS FOR THE SIDE BRACKETS AS SHOWN IN FIGURE 1.

NOTE; WIRING HARNESS MAY NEED TO BE RELOCATED TO ALLOW ACCESS TO CENTER ATTACHMENT HOLES ON

THE DIVER'S SIDE FRAME RAIL.

5. RAISE CENTER SECTION INTO POSITION AND INSTALL FASTENERS AS SHOWN IN FIGURE 1.

6. TIGHTEN ALL FASTENERS TO THE BELOW TORQUE VALUE. THE M14 NUT BLOCK MAY REQUIRE A WRENCH TO HOLD IT

UNTIL IT'S TIGHT AGAINST FRAME SURFACE.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent

entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle

and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and

SAE J684.