Changing The Transmission Belt; Adjusting The Transmission - Toro TurfMaster 22210 Manual Del Operador

Figure 47
1. Mark the cable here
Figure 48
1. Slack—3 mm (1/8 inch)
8. Torque the cable-clamp screw to 11 to 14 N∙m
(99 to 121 in-lb) to lock the adjustment in place.
9. Install the belt cover with the 4 bolts that you
removed in step 3.
10. Connect the wire to the spark plug.
11. Check the operation of the blade-brake clutch;
refer to Servicing the Cutting Blades (page
Changing the Transmission
Belt
Service Interval: Every 250 hours
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the 4 bolts that hold the belt cover to
the machine housing.
Note:
Save the bolts for installing the belt cover
to the machine housing.
4. Remove the belt cover.
5. Remove any debris from under the belt cover.
6. Loosen the bracket and rotate the bracket
forward
Note:
The bracket prevents the transmission
from tipping to the point where the transmission
belt comes off.
g208923
1. Transmission tension
spring
2. Bracket
3. Transmission
7. Remove the transmission tension spring.
8. Remove the transmission belt from the
g208920
transmission pulley.
9. Remove the transmission belt.
10. To install a new transmission belt, reverse the
steps above.

Adjusting the Transmission

If the machine starts to lose traction, check and adjust
the transmission.
1. Shut off the engine and wait for all moving parts
22).
to stop.
2. Disconnect the wire from the spark plug.
3. Loosen the bolt and nut holding the bracket into
place.
4. Adjust the bracket so that it is in contact with the
transmission.
Note:
The bracket prevents the transmission
from tipping to the point where the transmission
belt comes off.
5. Tighten the bolt and nut to secure the bracket
into place.
28
(Figure 49).
Figure 49
4. BBC belt
5. Transmission belt
g196531