Preparing The Engine; Removing The Machine From Storage - Toro TurfMaster 22210 Manual Del Operador

Preparing the Engine

1. While the engine is still warm, change the
engine oil and the oil filter; refer to
Engine Oil (page 19)
(page 20).
2. Remove the spark plug.
3. Using an oil can, add about 30 ml (1 fl oz), of
motor oil to the engine through the spark-plug
hole.
4. Slowly pull the starter rope several times to
distribute oil throughout the cylinder.
5. Install the spark plug but do not connect the wire
to the spark plug. Secure the wire so that it does
not come into contact with the spark plug.
Removing the Machine
from Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine
rapidly using the starter to blow excess oil from
the cylinder.
3. Inspect the spark plug and replace it if it is dirty,
worn, or cracked; refer to the engine owner's
manual.
4. Install the spark plug and tighten it to the
recommended torque of 20 N∙m (180 in-lb).
5. Perform any needed maintenance procedures;
refer to Maintenance (page
6. Check the engine-oil level; refer to
Engine-Oil Level (page
7. Fill the fuel tank with fresh fuel; refer to
the Fuel Tank (page
8. Connect the wire to the spark plug.
Changing the
and Changing the Oil Filter
18).
Checking the
11).
Filling
10).
30