bebeduE VIVA Manual Del Usuario página 26

EN
USING THE BRAKE (Fig. 9)
To activate the brake, stand on the brake bar as shown in the picture. To release the brake, lift the brake
bar upwards.
HOW TO FOLD THE PUSHCHAIR (Fig. 10)
Before folding the chair, ensure that the backrest is in the vertical position and that the hood is folded
down.
To fold the pushchair, push the lever to the side (A) while squeezing the handle lock located in the
centre of the handle (b), and twisting the handle forward (C) and pushing the handle downwards to
fold the pushchair.
To fold the pushchair completely, push downward until the automatic safety lock clicks into place and
locks the pushchair.
SAFETY HARNESS (Fig. 11)
This pushchair has a ve-point safety harness.
To unfasten the harness, press the central button (A).
Make sure that the baby's legs are either side of the crotch strap.
Insert the tabs on the ends of the chest straps into the xture points on the side clasps (B).
Ensure that the tabs are fastened securely into the side clasps.
Then introduce the side clasps into the central buckle.
Adjust the belt straps around the baby's waist so that it ts properly.
WARNING: Never use the crotch strap without the waist belt. To ensure your baby's safety, always have
the safety harness fastened.
HOW TO CHANGE THE HARNESS (Fig. 12)
The Viva pushchair is suitable for newborn babies and infants up to 15 kg. To cater for the di erence in
sizes, there are two di erent lengths of harness, which can be adjusted.
The seat comes tted with the harness in the 0 months position (A).
To change unbuckle and remove the harness chest protectors. Pass the shoulder and the waist straps
through the upper, higher slots (B).
Pull them through from the front of the pushchair (C). Next pass the shoulder and the waist straps
through the slots that are closest to the sides of the pushchair (D).
Finally, adjust the shoulder and the waist straps to t your baby and replace the shoulder
padding (E).
HOW TO PLACE THE HEAD BARRIER (Fig. 13)
The use of the head barrier when the buggy is in its most reclined position is highly
recommended, especially for children under 6 months.
To assemble the head barrier, lift it and snap the button closures to the side of the seat (A).
To disassemble the head barrier, fold it down behind the seat and fold the aps up and
snap the button closures to the side of the seat (B).
HOOD WITH VISOR (Figura.14)
Hood with folding visor for added protection.