Technical Data - Grohe RAPIDO E Manual Del Usuario

GB
Applications
Can be used in conjunction with:
• Pressurised storage heaters
• Thermally controlled instantaneous heaters
• Hydraulically controlled instantaneous heaters
Operation with unpressurised storage heaters (displacement
water heaters) is not possible.
Use as:
• Bath installation
• Shower installation

Technical data

• Flow pressure
- min.
- recommended
- Operating pressure max.
• Test pressure
If static pressure exceeds 5 bar, a pressure reducing
valve must be fitted.
Avoid major pressure differences between hot and
cold water supply.
• Flow rate at 3 bar flow pressure:
• Temperature:
Hot water inlet
Recommended (energy saving)
Thermal disinfection possible
• Water connection
Important note:
Do not install shut-off valves in the outlet pipe (mixed
water) downstream of this concealed mixers.
Note:
The GROHE Rapido E concealed universal fitting body is
intended for use as a bath or shower installation.
In the case of concealed shower mixers with bath filling and
overflow sets, observe the following:
• According to EN1717 an approved safety device is
stipulated. A special accessory can be used for this purpose
(see Replacement parts, fold-out page I, Prod. no.: 29 008).
• The approved safety device must be installed above the
bathtub rim, see fold-out page I!
Installation
Installation, see fold-out page II Fig. [1].
Refer to the dimensional drawing.
For different installation options, see the pre-drilled holes
in Fig. [1].
Prepare the holes for the single lever mixer and slots
for the pipe.
Align single lever mixer using fitting template and install,
see Fig. [2].
• The finished surface of the wall must lie within the area (A)
of the fitting template.
• The hot water supply must be connected on the left and the
cold water supply on the right.
Align single lever mixer, see Fig. [1].
Place a spirit level on the cams (B) of the mounting template.
Connect the pipes, see Fig. [2].
• When installing the shower mixer, the plug (C) provided,
0.5 bar
see fold-out page I, must be sealed in the unused outlet (top
1 - 5 bar
or bottom).
10 bar
A soldered connection is not permissible, as this could
16 bar
damage the built-in sound absorber.
Open cold and hot-water supply and check fitting connections
for water-tightness.
Approx. 25 l/min
Flush pipe thoroughly.
max. 70 °C
Fit substrate for sealant, see Figs. [3] and [4].
60 °C
1. Apply sealant or adhesive, see Fig. [3].
2. Remove (D1) centre piece of substrate (D) by cutting
hot - left
through the tabs (D2).
cold - right
3. Push the substrate (D) over the fitting template.
4. Apply sealant or adhesive again, see Fig. [4].
Plaster and tile the wall, see Fig. [5].
Do not cut the fitting template before final installation.
Replacement parts, see fold-out page I (* = special
accessories).
2