Troubleshooting - TEFAL Smart'N Light CM6008 Manual De Instrucciones

When is it time to descale?
• The frequency of descaling depends on water hardness and the number
of coffee cycles. When users observe signs such as extended cycle
lengths, intense boil-off, loud noise levels at the end of the cycle or
stoppage during a cycle, this means your machine requires descaling.
• Descaling the coffee maker must be performed approximately once a
month, depending on the water hardness.
How to descale your coffee maker
• Use a descaling solution or 0.5 L of white vinegar diluted in 0.5 L of cold
or warm water. Fig. 16.
• Pour the solution into the water tank. Fig. 17.
• Do not put any coffee in the filter and press the ON/OFF button (J) to
start the descaling cycle. Fig. 18.
• Please wait until the end of the cycle.
• To rinse the machine, start 2 complete 10-cup cycles with water, but
without coffee.
• Repeat the operation as needed.
• The guarantee does not cover coffee makers that are inoperative or
which run badly due to a lack of descaling.

TROUBLESHOOTING

PROBLEM
The coffee does not infuse
or the appliance does not
turn on.
The appliance appears to
leak.
The infusion requires lots
of time.
• Make sure that the appliance is properly plugged into a
functioning socket.
• The water reservoir is empty.
• There was a power failure.
• Unplug the machine, and then plug it in again.
• The clock time must be reset after a power failure.
• The automatic stop function has switched the appliance
off. Turn off the appliance and then turn it on again to
make more coffee. For more information, see the section
"Coffee Preparation".
• Make sure that the water reservoir has not been filled
beyond the maximum limit.
• Ensure that the water reservoir is not damaged.
• It may be time to descale the appliance.
• For more information, see the section "Descaling".
SOLUTION
EN
23