Changing Harness Strap Slots; Overhead Shield Adjustment - Graco STE Manual De Instrucciones

OPERATIONS and ADJUSTMENTS
6

Changing Harness Strap Slots:

The harness straps must go into the slots
even with or just above the shoulders.
A To adjust harness straps:
Remove straps from harness plate
and adjuster bar (fig. a).
B Pull strap ends through slots and reinsert
them in the correct slots (fig. b).
C Reassemble straps onto adjuster bar
exactly as shown (fig. c).
D Push adjuster bar down (fig. d).
E Rotate lock down (fig. e).
NOTE:
• Make sure both harness straps are
securely attached within Harness Plate
and Adjuster bar and locked into place
with Harness Lock.
• Make sure straps are NOT twisted.
20
(continued)
7 Overhead Shield Adjustment (fig. f):
• To adjust: Press both buttons down and
move shield to desired position closest to
child. Release buttons to lock shield into
place. Check by pulling out on shield.
NOTE: Shield does not need to contact
child when in closest position; harness
system restrains child.