Changing Harness Strap Slots - Graco ComfortSport Manual De Instrucciones

OPERATIONS and ADJUSTMENTS
7

Changing Harness Strap Slots:

A Loosen harness straps:
Lift and hold metal release bar.
Pull harness straps out.
B Remove both shoulder harness strap loops
from Splitter Plate on back of car seat.
C Change harness strap slots.
Make sure harness straps are threaded
through matching slot of seat pad and
car seat.
It may be necessary to remove seat pad
from top of car seat while relocating.
20
(continued)
D Re-attach harness strap loops to Splitter
Plate:
5-Point Models (fig. e):
• For Infants or Small Toddlers:
Put Top right strap loop on Splitter
Plate first, then attach Top left strap
loop.
NOTE: Make sure ends of straps are
behind Splitter Plate.
• For Toddlers:
Put Bottom right strap loop on Splitter
Plate first, then attach Bottom left strap
loop.
Overhead Shield Models (fig. f):
Put right strap loop on Splitter Plate
first, then attach left strap loop.
NOTE:
• Make sure both strap loops are securely
attached within Splitter Plate hook.
• Make sure straps are NOT twisted and
are routed behind stand (fig. g).