Transport - Kärcher NT 22/1 Ap Manual Del Usuario

Working with electrical power tools
Only for appliances with built-in socket:
DANGER
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
 Connect the mains plug of the electric
power tool to the vacuum cleaner.
The vacuum cleaner is in standby
mode.
 Set the main switch to program 2.
Note: The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Note: The vacuum cleaner starts automat-
ically within 0.5 seconds and continues to
run for 5 seconds after the power tool has
being switched off.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
 Remove the elbow from the suction
hose.
 Unscrew the clip connection.
 Screw on the rubber sleeve.
Illustration
 Connect the rubber sleeve to the elec-
tric power tool.
Semi-automatic filter dedusting
Note: A filter dedusting every 5 to 10 min-
utes will increase the life of the cartridge fil-
ter.
Note: The semi-automatic filter dedusting
function can only be switched on when the
appliance is switched on.
 Press the semi-automatic filter dedust-
ing key five times. The cartridge filter is
automatically cleaned through an air jet
(pulsating sound).
 Power dedusting (especially with se-
vere soiling): Cover the suction tube or
the bender with your hand and simulta-
neously press the semi-automatic filter
dedusting key five times.
10
Emptying the dirt container
CAUTION
Please observe the local provisions regard-
ing the wastewater treatment.
– The vacuum channel is equipped with a
float.
– When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
 Switch off the appliance at the main
switch.
Turn off the appliance
 Press the semi-automatic filter dedust-
ing key five times.
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction pipes, the suction
hose and the mains cable as shown in
the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
– 6
EN

Transport