HIKOKI CR 18DA Instrucciones De Manejo página 10

English
SPECIFICATIONS
Model
Voltage
No-Load Speed
Stroke
Mild Steel Pipe
Vinyl Choride
Pipe
Capacity
Mild Steel Plate
Wood
Weight*
* According to EPTA-Procedure 01/2014
Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Before
charging
While charging Lights
Charging
Pilot complete
lamp
(red)
Charging
impossible
Overheat
standby
● Regarding the temperatures and charging time of the battery.
The temperatures and charging time will become as shown in Table 2.
Type of battery
Temperatures at which the
battery can be recharged
Charging voltage
Battery
Charging time,
approx. (At 20°C)
NOTE
The recharging time may vary according to the ambient temperature and power source voltage.
00Book̲CR18DA.indb 10 00Book̲CR18DA.indb 10
CR18DA
18 V
0–3200 min
–1
13 mm
O.D. 50 mm
O.D. 50 mm
12 mm
50 mm
1.7–2.2 kg
Table 1
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
Flickers seconds. (off for 0.1 seconds)
Lights for 1 second. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Table 2
Charger
V 14.4
BSL14xx series
(4 cells) (8 cells)
BSL1415S : 20
BSL1415 : 22 BSL1430 : 45
BSL1415X : 22 BSL1440 : 60
min
BSL1420 : 30 BSL1450 : 75
BSL1425 : 35 BSL1460 : 90
BSL1430C : 45
10
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
UC18YFSL
Li-ion
0°C–50°C
BSL18xx series
(5 cells) (10 cells)
BSL1815S : 20
BSL1815 : 22
BSL1830 : 45
BSL1815X : 22
BSL1840 : 60
BSL1820 : 30
BSL1850 : 75
BSL1825 : 35
BSL1860 : 90
BSL1830C : 45
BSL1850C : 75
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge.
(Charging will
commence when
battery cools)
18
Multi volt
series
(10 cells)
BSL36A18 : 75
BSL36B18 : 120
2021/02/08 12:08:23 2021/02/08 12:08:23