Radio Reception; Setting The Alarm Time - Philips AJ 3935 Manual Del Usuario

RADIO

RADIO RECEPTION

1. Press RADIO•BAND to switch on the radio mode.
– RADIO and the last waveband selected appears in the
display.
2. Press RADIO•BAND again if you wish to select another
waveband.
3. Turn the TUNING wheel to find your station.
To improve reception:
FM: uses the pigtail aerial. Adjust the position of the pigtail
slightly for optimum reception.
MW: uses a built-in aerial. Direct the aerial by adjusting the
position of your set.
4. Adjust the sound with VOLUME 4 or 3.
5. Press 9 STOP•OFF to switch off the radio.
– RADIO disappears from the display.
Note:
If you want to listen to the radio during a buzzer melody or CD
mode alarm call/ repeat alarm, you must first stop the alarm by
pressing either one of the following:
– 9 STOP•OFF;
– ALARM 1 or 2 MODE OFF;
– 24-HOUR ALARM RESET.

SETTING THE ALARM TIME

General
Two different alarm times, ALARM 1 or 2 can be set in a variety of
modes. This can be useful when for example you need to wake up
at a different time during the week and at the weekend.
Setting ALARM 1 or ALARM 2 time
1. Adjust the clock control to SET ALARM 1 or 2 TIME.
2. Press UP7 or DOWN8 to adjust both the hours and minutes:
– with your finger held down on UP7 or DOWN8
respectively, the time will increase/ decrease rapidly and
continuously from minutes to hours.
– press UP7 or DOWN8 briefly and repeatedly to adjust the
time slowly, minute by minute.
3. Release UP7 or DOWN8 when you have reached the correct
alarm time setting.
4. Adjust the clock control back to CLOCK.
5. Select your choice of alarm mode by pressing ALARM 1 or 2
MODE•OFF once or more until the display shows your choice
of alarm: buzzer
ALARM 2.
8
, radio or CD next to ALARM 1 or
SETTING THE ALARM