geberit AQUACLEAN MERA Instructions De Montage página 50

EN
4
Call up the [System flush] menu. Configure
switch-on behaviour.
System flush
off
✓ [on]= The system flush starts as soon as
a user is detected on the WC.
✓ [off] = The system flush starts before the
shower procedure as soon as the
<Shower> button is pushed. The flush
time before the shower procedure is
approx. 15 seconds.
5
Call up the [Orient. light colour] menu. Set
colour.
Orient. light colour
If Geberit Monolith Plus is installed, select
the same colour.
6
Call up the [Orient. light bright.] menu. Set
brightness.
Orient. light bright.
7
Call up the [Orientation light] menu.
Configure switch-on behaviour.
Orientation light
on approach
8
Call up the [WC lid detect. range] menu. Set
the sensor range.
WC lid detect. range
✓ Reliably detects the user.
The sensor must be configured so that the
WC lid does not lift up unintentionally.
9
Call up the [Basic settings] menu.
Basic settings
Result
✓ The settings are saved.
✓ The device is installed correctly.
50
on
white
Classic model
The basic settings of the device are set
from the rear of the remote control.
The following steps are shown in shortened
form. See user manual for an overview of
the complete menu.
Prerequisite
– Function test of the device was performed
successfully.
– Testing of the remote control was performed
successfully.
1
Launch [Basic settings] main menu via the
<left>/<right> arrow key.
Basic settings
Select submenus with the <up> and <down>
arrow keys. Configure settings with the
<left> and <right> arrow keys.
2
Call up the [Select language] menu. Set the
menu language.
Select language
English
3
Call up the [Water hardness] menu. Set the
hardness value in accordance with the local
water hardness.
Water hardness
hard
Range
soft
medium
hard
Set to [hard] if you do not know the local
water hardness.
54043197686759179-1 © 09-2018
966.729.00.0 (07)