Electrical Connection - Miele CM 6310 Instrucciones De Instalación Y Funcionamiento

All electrical work should be perfor-
med by a qualified electrician in
strict accordance with national and
local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Verify that the voltage, load and circuit
rating information found on the data
plate match the household electrical
supply. This data must match to pre-
vent damage to the coffee system. If in
doubt, consult a licensed electrician.
The data plate can be found behind the
drip tray inside the coffee system.
The appliance is supplied with a power
cable ready for connection to an AC
120 V 60 Hz supply.
Connect the coffee system only to a
properly installed outlet with grounding
contact.
Fuse rating must be at least 15 A.
The socket should be next to the ap-
pliance and easily accessible.
To reduce the risk of injury, do not dra-
pe cord over the counter top or table
top where it can be pulled on by chil-
dren or tripped over unintentionally.
Do not connect the appliance to a po-
wer inverter or directly to power produ-
ced outside of the normal electrical grid
(i.e. direct solar or wind power source).
Direct connection to such power sour-
ces can cause power surges and trip-
ped breakers when the appliance is tur-
ned on, and could damage the applian-
ce.

Electrical connection

Do not connect the appliance to energy
saving plugs or outlets. The reduction
of power to the appliance caused by
these devices will cause the appliance
to run hot and may damage it and/or
shorten its usable life.
Do not operate any appliance with a
damaged cord or plug. Contact Miele
Technical Service.
h it up through the opening at the back
of the machine.
If there is any question concerning
the electrical connection of this ap-
pliance to your power supply, plea-
se consult a licensed electrician or
contact Miele's Technical Service
Department.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED
77