Safety Instructions; Mounting Instructions - Kärcher B 80 W Guia De Inicio Rapido

Please read and comply with
these instructions prior to the
English
mounting of your appliance. Retain these
mounting instructions for future reference
or for subsequent possessors.
Description
These mounting instructions describe the
installation of the attachment set spray suc-
tion into a B 80 W.

Safety instructions

Assembly must be carried out by a
–
qualified specialist.
Empty the fresh water tank and waste
–
water reservoir.
Turn off the appliance and disconnect
–
the battery.

Mounting instructions

 The assembly and disassembly of ap-
pliance parts as well as adjustment
tasks are described in the service man-
ual of the appliance.
 Test all functions of the appliance after
the modification.
 When working on the device, please al-
ways use the current circuit diagram in
DISIS.
Assembly
 Remove the covering plate.
 Fit the adapter to the ball valve handle
shaft.
 Install the ball valve unit into the cover-
ing plate. The connector is used as a
screw connection. Install the ball valve
handle from the outside
 Sever supply line from the fresh water
tank at a distance of 50 mm from the
pump.
 Insert a tee in the hose and secure it by
means of hose clamps.
 Connect the tee and the water pump
with a hose (DN12 / 500 mm long) and
secure it by means of hose clamps.
 Connect the water pump and the ball
valve unit with a hose (DN 12 / 325 mm
long) and secure it by means of hose
clamps.
Flow pattern
 Bolt the floor nozzle bracket to the ap-
pliance.
 Fit the bracket into the homebase hold-
ing rail and bolt it to the appliance.
1
-
EN
 Connect the fresh water hose of the
floor nozzle with the connector of the
ball valve unit.
 The suction hose is connected to the
hose of the vacuum bar during opera-
tion.
3