RIB APP+ Guia De Inicio Rapido página 11

Para administrar la unidad de control a través de bluetooth 4.2
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

THE APP+ CARD ALLOWS THE APP TO IDENTIFY THE TYPE OF Pc board. THE APP SHOWN THESE SPECIFIC PARAMETERS FOR ITS CONFIGURATION
CONTROL PANEL
"GATE OPENED" BLOCK
"ALWAYS CLOSE" COMMAND
DISPLAY CARD APP+/APP TYPE AND CONNECTED MODULES
DISPLAY CARD APP+/APP SERIAL NUMBER
DISPLAY CARD APP+/APP FW VERSION
DISPLAY CARD APP+/APP HW VERSION
DISPLAY Pc board SERIAL NUMBER
DISPLAY Pc board FW VERSION
DISPLAY Pc board HW VERSION
INSTALLER PARAMETERS
FORCE (TORQUE)
SPEED (RUN)
SPEED SLOWDOWN AT THE END OF OPENING
SPEED SLOWDOWN AT THE END OF CLOSING
SPEED SLOWDOWN AT THE END OF OPENING/CLOSING
MOTOR 1 - SLOWDOWN SPACE AT THE END OF OPENING
MOTOR 1 - SLOWDOWN SPACE AT THE END OF CLOSING
MOTOR 2 - SLOWDOWN SPACE AT THE END OF OPENING
MOTOR 2 - SLOWDOWN SPACE AT THE END OF CLOSING
SENSITIVITY OF CURRENT SENSOR
PROGRAMMABLE AUXILIARY RELAY CONTACT
EDGE 1
EDGE 2
PHOTOCELL 1
PHOTOCELL 2
AUTOTEST PHOTOCELLS
CLOSURE AFTER THE TRANSIT OF THE VEHICLE "OK CLOSE"
TRAFFIC LIGHT CONTROL "TLC"
ELECTRIC LOCK
GATE LOCK MAGNETS (AU VERSION)
GATE LEAVES OPENING DELAY TIME
GATE LEAVES CLOSING DELAY TIME
CONTEMPORARY OPENING/CLOSING
STOP COMMAND WITH BRIEF INVERSION
GRADUAL START
ELECTRONIC BRAKE
HELP TO RELEASE THE ELECTRIC LOCK
ENERGY SAVING (ACCESSORIES OFF WITH GATE STILL)
LOCK / UNLOCK SETTINGS
LOCK / UNLOCK COMMANDS
"HOLD-TO-RUN CONTROL" WITH SAFETIES ENABLED
INDUSTRIAL MODE (OPEN COMMAND IMPULSIVE, CLOSE MAINTAINED)
SYNCHRONIZATION OF 2 PC BOARDS
"ALWAYS WORKS" MODE IN PRESENCE OF FAULTY SAFETY DEVICES
MAINTENANCE CYCLES (ESTABLISHED, TOTAL, PARTIAL)
SPEED CHANGE IN CASE OF OVERCURRED CYCLES
VISUALIZATION OF PLANTS AND MAINTENANCE LOGS REGISTER
MOTOR TYPE SELECTION
DEFAULT SETUP RESET (REMOTE CONTROLS EXCLUDED) AND PARTIAL
SETUP RESET (ENGINE TIMES EXCLUDED)
TIMED OPERATION OR WITH ELECTRIC LIMIT SWITCHES
SELECTION 1-2 ENGINES
CONFIGURATION COPY FROM A Pc board TO ANOTHER
REMOTES COPY FROM A Pc board TO ANOTHER
PROCEDURE TO CHANGE INSTALLER PASSWORD
L1
L1 24V
B2
WITH
BATTERIES
11
B2 24V/B2D 24V
P1
WITH BATTERIES
G
B
P1 24V
WITH
BATTERIES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

App8054App+ serie

Tabla de contenido