Return Of Goods; Safety Instructions - VALPES AXMART MT Serie Manual Del Usuario

DESCRIPTION
These electric actuators have been designed to perform the control of a linear valve or a reductor. Please consult us for any
different application. We cannot be held responsible if the mentioned actuators are used for any other purpose.
TRANSPORT AND STORAGE
 The forwarding agents being held as responsible for damages and delays of the delivered goods, the consignees are
obliged to express if applicable their reserves, prior to accept the goods. The goods delivered directly ex works are sub-
ject to the same conditions.
 The transport to the place of destination is carried out by using rigid packing material.
 The products must be stored in clean, dry, and ventilated places, preferably on appropriate palettes or shelves. Actuators
should not be stored upside down.
MAINTENANCE
 Maintenance is ensured by our factory. If the supplied product does not work, please check the wiring according to the
electric diagram as well as the power supply of the electric actuator in question.
 For any question, please contact our after-sales service.
 To clean the outside of the actuator, use a lint and soapy water. DO NOT USE ANY CLEANING PRODUCT WITH SOL-
VENT OR ALCOHOL.
WARRANTY

RETURN OF GOODS

 When the actuator receives his actuator, he must check its conformity according to its definition.
 The acceptance of the goods by the purchaser disclaims the supplier of all responsibility if the purchaser discovers any
non-conformity after the date of acceptance. In such case, the repair cost will be borne by the purchaser who will also
exclusively bear all financial consequences of any resulting damages. Returned goods will only be accepted if our prior
agreement has been given to this procedure : the goods must be sent free of all cost and being shipped solely and in their
original packing. The returned goods will be credited to the purchaser with a reduction of 40% on the unit's price charged
in accordance with the original invoice of the returned goods.

SAFETY INSTRUCTIONS

 The electric power supply must be switched-off before any intervention on the electric actuator (i.e. prior demounting its
cover or manipulating the manual override knob).
 Any intervention must only be carried out by a qualified electrician or persons instructed in accordance with the regulations
of electric engineering, safety, and all other applicable directives.
 Strictly observe the wiring and operation instructions as described in the manual: otherwise, the proper working of the
actuator can not be guaranteed anymore. Verify that the indications given on the identification label of the actuator fully
correspond to the characteristics of the electric supply.
 Any other use than that described by the manufacturer jeopardizes the protection provided by this apparatus.
MOUNTING INSTRUCTIONS
 Do not mount the actuator less than 30 cm from an electromagnetic disturbance source.
 Do not position the equipment so that it is difficult to operate the disconnecting device.
 Respect all safety rules during fitting, dismantling and porting of this apparatus.
20
(To be read prior to the installation of the product
(To be read prior to the installation of the product
)
)