KTM Power Parts 64112964044 Manual Del Usuario página 12

12
Mounting control unit
- Route the wiring harness of the control unit
desired half of the handlebar along the existing cables to the head-
light mask.
- Position upper bracket and lower bracket
tector (all included).
- Mount screws with circlips
- Stick double-sided adhesive tape
bracket .
- Stick on control unit and if necessary secure with cable ties
(included).
- Position cover, mount screws
Ensure that the cable can neither be kinked or pinched!
- Join plug-in connector .
- Connect control unit wiring harness to ACC2 of the vehicle wiring
harness.
NOTE
The cables have an adhesive sticker marked ACC 2.
- Route the cable without tension and if necessary secure with a
cable ties.
(included) from the
using rubber pro-
(all included) and tighten to 2 Nm.
(included) to the upper
and tighten to 5 Nm.