Xerox WorkCentre 7328 Guida Rapida página 10

Procedure for Setup of Scan to FTP/SMB
To use Scan to PC (FTP/SMB) you need to enable the applicable Ports (SMB or FTP client)
on the Device, and make sure that an IP address has been set on the machine.
Note
The configuration can also be performed using CentreWare Internet Services. For
information on how to use CentreWare Internet Services, refer to the Internet
Services section of this guide.
1. Display the System Administrator Menu screen.
a. Press the
b.
Enter the Login ID (11111) with the numeric keypad or the keyboard displayed
on screen, then touch Confirm.
c.
Press the
d. Touch the Tools tab.
2.
When using the SMB protocol, enable the SMB port.
a. Select System Settings.
b. Touch Connectivity and Network Setup.
c.
Select Port Settings.
d. Select SMB and then select Change Settings.
e.
Select Port Status and then select Change Settings.
f. Select Enabled then select Save.
g.
Select Close until the Port Settings screen is displayed.
3. When using the FTP protocol, enable the FTP client port.
a. Select System Settings.
b. Touch Connectivity and Network Setup.
c. Select Port Settings.
d.
From the Tools tab screen, select Network Settings, then Port Settings.
e. From the Port Settings screen, select FTP Client and then select Change
Settings.
f. Select Port Status and then select Change Settings.
g.
Select Enabled then select Save.
h. Select Close repeatedly until the Tools tab screen is displayed.
Copyright © 2007, Xerox Corporation. All rights reserved.
Log In/Out button.
Machine Status
button on the Control Panel.
Scan to FTP/SMB (Optional)
10