Prerequisites for Scan to Email Setup
Confirm that:
1.
An existing operational network using TCP/IP is available.
2.
The device must be setup with DNS and the Domain Name settings for the network.
have been correctly setup for the multifunction device.
Data to Setup Email
SMTP mail server Host
Name or IP address
SMTP login/password
WorkCentre Email address
Local email addresses
LDAP server address can
be enabled
* Only if the SMTP server requires login and password for authentication.
Procedure for Scan to Email Setup
1.
Press Login/Out, then type the Login ID 11111 and press Confirm.
2.
Machine
Press
3.
Select System Settings, then touch Connectivity and Network Setup.
4.
Select Port Settings.
5.
On the Port Settings screen, select Send E-mail and then select Change Settings.
6.
On the Send E-mail screen, select Port Status and select Change Settings.
7.
On the Send E-mail Port Status screen, select Enabled then select Save.
8.
Touch Close.
9.
On the Port Settings screen, select Receive E-mail, then select Change Settings.
10.
On the Receive E-mail screen, select Port Status, then Change Settings.
11.
On the Receive E-mail Port Status screen, select Enabled, then Save and Close.
12.
On the Port Settings screen, select Mail Notice Service, then select Change Settings.
13.
On the Mail Notice Service screen, select Port Status, then Change Settings.
14.
On the Mail Notice Service - Port Status screen, select Enabled, then Save.
15.
Select Close until the Tools tab screen is displayed.
Copyright © 2007, Xerox Corporation. All rights reserved.
Install Requirement
Required
Required*
Required
Optional
LDAP Host Name
Status, then touch the Tools tab.
If using an external mail
server, your Internet Service
Provider will provide you
with the mail server name or
IP address.
This email address will fill in
the "From" field on the
emails sent from the device.
A Local Address Book can
be created to store email
addresses.
Displays only email
addresses on the corporate
(LDAP) internal address
book.
2
Scan to Email
Comments